Home » 2 Way Radio » 2 Way Motorola Radio Programming » CABLE TO PROGRAM A MOTOROLA HT50/P100
CABLE TO PROGRAM A MOTOROLA HT50/P100 [message #25] Mon, 22 August 2005 01:11 Go to next message
root  is currently offline root
Messages: 206
Registered: December 2004
Senior Member
Cable Description:

Pin-1 is ground (attach to batt. ground )
Pin-8 is busy
Pin-24 is data

Interface to Radio:

When you take off battery and looking at the back of the radio, you will see two(2) contacts --NOT the battery contacts!-- the ones you want are recessed into the radio.
The top one is for pin 8 (busy) and the bottom is for pin 24 (data).
Connect a jumper between pins 4 and 11 on the DB25 at the RIB end.
Make whatever connections you can get to work to these pins as well as ground and power for the radio.
You should be able to read and program without any problems

[Updated on: Mon, 22 August 2005 01:12]


Re: CABLE TO PROGRAM A MOTOROLA HT50/P100 [message #113 is a reply to message #25 ] Tue, 06 March 2007 22:09 Go to previous message
celes_maxtrac  is currently offline celes_maxtrac
Messages: 10
Registered: February 2007
Junior Member
Thanks, Root. This helped.

__________________
Motorola Maxtrac Series Parts List - Download the Maxtrac Series Parts List Catalog by Motorola

[Updated on: Tue, 06 March 2007 22:22]


Goto Forum:
  


Current Time: Mon Mar 27 00:48:19 EDT 2017

Total time taken to generate the page: 0.02008 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 2.7.6.
Copyright ©2001-2007 FUD Forum Bulletin Board Software