Ham Radio: Radio Mods => IC-P7A MARS Mods

Members

Help

Home

Home » Ham Radio » Radio Mods » IC-P7A MARS Mods

Show: Today's Messages :: Show Polls :: Message Navigator

IC-P7A MARS Mods [message #135]

Wed, 30 May 2007 21:16

root
Messages: 99
Registered: December 2004

Member

IC-P7A MARS Mods

The following mod works exactly as described for the Icom IC-P7A (see mod for the IC-E7)

NOTE: The sticker is a very small (1cm) one and in the P7 the pads are shorted with a SMT diode. With a steady hand, a jewlers loupe, and some really small tweezers, you can pluck the diodes off lohoneyions 3 and 4 (as noted below.) As per EB4EQA:

TX bands configuration via 4 solder pads in the PCB, behind a square sticker lohoneyed under the battery, on the top-left corner.

I've number the pads as seen while looking to the back of the transceiver, with no battery and the PTT looking to your right.

  1234    VHF_TX     UHF_TX

  OOOO   136-174    400-479

  OOOS   136-174    430-440

  OOSS   144-146    430-440 (factory)

O = Open
S = Short

Procceed at your own risk.

[Updated on: Wed, 30 May 2007 21:17]

Report message to a moderator

Previous Topic:	Open Icom IC-M800 or IC-M810 to ham Frequency
Next Topic:	Programming Cable for Icom IC-F12

Goto Forum:

-=] Back to Top [=-

[ Generate printable PDF ] [ Syndicate this forum (XML) ] [

]

Current Time: Thu Sep 9 17:23:43 EDT 2010

Total time taken to generate the page: 0.01870 seconds

.:: Contact :: Home ::.