Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio Mods » Alinco Mods » Alinco DR1200T Full Band Mod (Alinco DR1200T Full Band Mod)
Alinco DR1200T Full Band Mod [message #3098] Wed, 29 April 2015 01:06
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member
Alinco DR1200T Full Band Mod

Step 1. Remove 2 screws located on top of cover.
Step 2. Loosen the 4 screws on both sides of top cover (do not remove).
Step 3. Remove top cover
Step 4. Locate Yellow wire Loop behind tuning Knob (this wire loops from
the control board mounted on front pannel).
Step 5. Cut loop and tape ends.
Step 6. Replace top cover.
Step 7. Reset radio (press 'F' and VCO/M keys together. While holding
down keys turn off and on Power).

Factory settings will be restored however the new frequency range will
be from 132 to 173 MHz. Any memory will have to be reprogramed.
These insructions are from Alinco, I've done them to my set and
it works great.
Previous Topic: Alinco DR-110 Full Band Mod
Goto Forum:
  


Current Time: Thu Nov 23 09:48:26 EST 2017

Total time taken to generate the page: 0.03464 seconds